Compression Packings


Bulk Form
For All Pump Or Valve
Applications
Available On Spools, Reels, or Coil
Form
Braided and Laminated Types
Round, Square Or Rectangular
Cross-sections


Materials
Aramid
Carbon Filament
Expanded Graphite
Flax
Fiberglass
Gore GFO®
Grafoil® Ribbon
Graphite Filament
Kevlar®
Metallic
PBI®
Ramie
Rubber & Duck
Teflon®


Die Formed Packing Sets
Controlled Density & Size
Increased Service Life
Combination of Materials & Patented Designs
Reduce Overall Down Time
Reduce Fluid Loss & Power
Generation Costs


Die formed rings can be produced in thousands of sizes. When ordering, specify the material, the inside diameter, the outside diameter, the ring/set height (and density if necessary).


Selection of Materials

The proper selection of packing materials is dependent on the operating conditions of the equipment. Six parameters of the equipment must be known before a proper packing recommendation can be made. The acronyn "STAMPS" is used to gather this information:

S  = Size - cross section
T  = Temperature - of media being sealed
A  = Application - type of equipment (i.e. pumps, valves, etc.)
M  = Media - material being sealed
P  = Pressure - of media being sealed
S  = shaft speed in FPM (pumps only)

Warning - Properties/applications shown throughout this Website are typical. Your specific application should not be undertaken without independent study and evaluation for suitability. For specific application recommendations, consult Beacon Gasket & Seals Co. Failure to select the proper sealing products could result in property damage and/or serious person injury. Performance data published in this Website has been developed from field testing, customer field reports and/or in-house testing. While the utmost care has been used in developing this Website, we assume no responsibility for errors. Specifications subject to change without notice.